🎯⚙️ STEM in Action: Rubber Band Launcher Project! ⚙️🎯
- Kids Elite Club
- May 3
- 1 min read
Check out this fun and interactive engineering project! Students are building and testing a rubber band launcher system powered by simple electronics and mechanical design.
🔧 What’s happening here?
The device uses a motorized or servo-controlled mechanism to pull back and release a rubber band.
A control board allows students to adjust timing and release, creating consistent launches.
The structure (partly 3D-printed or assembled) keeps everything aligned for accurate shots.
🧠What students learn:
Basics of force, tension, and energy transfer
Introduction to motors and control systems
Hands-on engineering design and testing
Problem-solving through trial and improvement
🚀 From simple materials to smart design, this project turns physics into something you can see, build, and launch!
Comments